NSE7_SDW-6.4 Practice Exam Tests Latest Updated on Oct-2021
Pass NSE7_SDW-6.4 Exam in First Attempt Guaranteed Dumps!
NEW QUESTION 12
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify incoming interfaces in SD-WAN rules.
- B. Configure SD-WAN rules interface preference.
- C. Select SD-WAN balancing strategy.
- D. Specify outgoing interface routing cost.
Answer: B,D
NEW QUESTION 13
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- C. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- D. It acts as a policy compliance entity to review all managed FortiGate devices.
- E. It improves SD-WAN performance on the managed FortiGate devices.
Answer: D,E
NEW QUESTION 14
Which statement about using BGP routes in SD-WAN is true?
- A. VPN topologies must be form using only BGP dynamic routing with SD-WAN
- B. Learned routes can be used as dynamic destinations in SD-WAN rules
- C. Adding static routes must be enabled on all ADVPN interfaces.
- D. Dynamic routing protocols can be used only with non-encrypted traffic
Answer: A
NEW QUESTION 15
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two )
- A. All the existing sessions will continue to use port2 and new sessions will use port1
- B. All the existing sessions will be blocked from using port1 and port2
- C. All the existing sessions with no SNAT will start using port1 as the outgoing interface instead of port2
- D. All the existing sessions using SNAT will start using port1 as the outgoing interface instead of port2.
Answer: C,D
NEW QUESTION 16
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. The zero-touch provisioning process has completed internally, behind FortiGate.
- B. A factory reset performed on FortiGate.
- C. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- D. The FortiGate cloud key has not been added to the FortiGate cloud portal.
- E. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
Answer: A,D
NEW QUESTION 17
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)
- A. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- B. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- C. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- D. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
Answer: B,D
Explanation:
Explanation/Reference:
NEW QUESTION 18
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub
- B. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- C. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links
- D. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance
Answer: A,C
NEW QUESTION 19
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
- B. Packets exceeding the configured concurrent connection limit are dropped based on the priority configuration.
- C. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
- D. The packet exceeded the configured bandwidth and was dropped based on the priority configuration.
Answer: A
NEW QUESTION 20
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set cost 15.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B
NEW QUESTION 21
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link member.
- B. diagnose sys virtual-wan-link neighbor.
- C. diagnose sys virtual-wan-link service
- D. diagnose sys virtual-wan-link route-tag-list
Answer: A
NEW QUESTION 22
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. Each VPN device has a unique pre-shared key configured separately on phase one.
- B. ADVPN should only be enabled on unmanaged FortiGate devices.
- C. On the hub VPN, only the device needs additional phase one settings.
- D. The protected subnets should be set to address object to all (0.0.0.0/0).
Answer: A
Explanation:
Explanation/Reference:
NEW QUESTION 23
Refer to exhibits.
Exhibit A.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?
- A. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- B. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- C. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- D. Both SD-WAN member interfaces have used separate SLA targets.
Answer: D
NEW QUESTION 24
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Configure the IKE mode to be aggressive mode.
- B. Use different proposals are used between the interfaces.
- C. Specify a unique peer ID for each dial-up VPN interface.
- D. Use unique Diffie Hellman groups on each VPN interface.
Answer: B,D
NEW QUESTION 25
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth.
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
Explanation:
Explanation/Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 26
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.
- B. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- C. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance.
- D. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.
Answer: B,D
NEW QUESTION 27
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Configure an SD-WAN rule to load balance all traffic without VoIP.
- B. Place the troublesome link at the top of the interface preference list.
- C. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- D. Choose the suitable interface based on the interface cost and weight.
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: C,E
NEW QUESTION 28
Which statement reflects how BGP tags work with SD-WAN rules?
- A. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
- D. BGP tags match the SD-WAN rule based on the order that these rules were installed.
Answer: B
NEW QUESTION 29
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on portl that match only FIRSTJVPN.
Which two configuration changes must be made to both IPsec
VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two )
- A. Configure a unique peer ID for each dial-up VPN interface
- B. Use different proposals are used between the interfaces.
- C. Use unique Diffie Hellman groups on each VPN interface
- D. Configure the IKE mode to be aggressive mode
Answer: A,D
NEW QUESTION 30
Which statement reflects how BGP tags work with SD-WAN rules?
- A. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: A
NEW QUESTION 31
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )
- A. Matched traffic failed RPF and was caught by the rule.
- B. An absolute SD-WAN rule was defined and matched traffic.
- C. Traffic has matched none of the FortiGate policy routes.
- D. The FIB lookup resolved interface was the SD-WAN interface.
Answer: C,D
NEW QUESTION 32
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. The use of Diffie Hellman keys is limited by the responderand needs initiator acceptance
- B. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- C. XAuth is enabled as an additional level of authentication which requires a username and password
- D. A peer ID is included in the first packet from the initiator, along with suggested security policies
Answer: C
NEW QUESTION 33
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link sla-lcg
- C. diagnose sys virtual-wan-link intf-sla-log
- D. diagnose sys virtual-wan-link log
Answer: A
NEW QUESTION 34
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It tags each route and references the tag in the routing table.
Answer: C
NEW QUESTION 35
......
NSE 7 Network Security Architect Free Certification Exam Material from TorrentVCE with 37 Questions: https://www.torrentvce.com/NSE7_SDW-6.4-valid-vce-collection.html
NSE7_SDW-6.4 Dumps Full Questions - Exam Study Guide: https://drive.google.com/open?id=15fU_1xFspN8nTO2ejx4jyUAXLR6QkoHt